On 24/02/2011 9:30 AM, Bill Pragnell wrote:
>> I had the same problem with Lucy, using MeshLab. Somehow I could not get it
>> >  converted.
> What seemed to be the issue? I also converted Lucy (I think with Meshlab +
> Poseray) a couple of years ago and had no problems. I did lower the triangle
> count a bit, since the file size was vast and I knew most of it would be
> sub-pixel in the scene I was making...
>
>
MeshLab fails with an error message saying that the application has 
requested the Runtime to terminate in an unusual way.

PoseRay might do it. But slowly, slowly!
After about 10 minutes loading the PLY file the % completed bar is at 
about 2%.

-- 
Regards
     Stephen

Post a reply to this message